Got a lot of work done on the brewery tonight. I picked up some paint stripper from Lowes and set into the bottom panel with it to see if this ugly coating would come off. It came off nooooo problem. I’m intending to paint the whole control box gloss black. The paint stripper is nasty stuff. Ate right through my nitrile safety gloves and by time I realized all the fingertips on my left hand were burning and tingly. That sucked.
While the stripper was working I started laying out and drilling the front panel. I drilled all the major round holes and pilot holes for all the rectangular holes except two that I am not sure about yet. I’m hoping I can cut the rectangles on my mill but I am not sure if the whole thing will fit in there. That’s tomorrow experiment.
Finally, because I couldn’t stand it any more, I installed some of the major components into the front panel. It’s looking really great. I am super excited to get it finished up. Tomorrow I am going to get the rectangular holes started on the mill (hopefully), set to stripping the main box and get the bottom panel primed and painted.
The control box is turning out to be a lot more work than I expected, but it’s turning out really nice so I don’t mind. It’s bugging me that I still have not put power to a kettle but I think it will be worth it in the end. I want the system to look as good as it runs and I’m getting there.
[slickr-flickr tag=”brewery20100630″]